exxos's Atari, Amiga & retro forum

The connectors I have have no spring in them at all. The card had a serious tendency to flop around.

@supaduper what do you think?

terriblefire wrote: 08 Feb 2019 14:04 The connectors I have have no spring in them at all. The card had a serious tendency to flop around.

@supaduper what do you think?

No real problems here Steve, I suppose if you wanted to manually file more of a bevel on the TF330 you can I suppose, because you moved the inner layers on the PCB so they do not encroach into the card edge like on the Rev1 am I correct bud ?

Just to say that if you can file a bigger bevel easily, as I did on a few of the TF328`s with ease :)

Yeah there are no inner layers beyond the notch.

Cheers Steve

Then what I say to Alen is get a small needle file and manually increase the bevel on the Rev 2 , like I said I have done a few of the TF328`s when they did not put a bevel on them and I filed a bevel on one in less than a couple of minutes. piece of pi$$ :)

I pay the board house to do this but they never do

Hello Stephen,
got parcels You sent to me, have built rev.2 TF330 with XC95288XL,
can You please recompile firmware for it, otherwise i am unable to flash
Thank You

already published

https://github.com/terriblefire/terribl ... _alpha.zip

terriblefire wrote: 08 Feb 2019 22:13 already published

https://github.com/terriblefire/terribl ... _alpha.zip

Nope Steve,
this jed is for 144 , not for 288 :?

you nutcase.. i'll do that in in the morning

Closeup pic of the damage... And a 1.2mm board sitting nicely ;)