Page 3 of 3
Re: H5 A5 BOM (or lack of)
Posted: 05 Nov 2020 00:06
by PaulJ
@exxos | @Icky, getting ready to shoot the juice to the first H5. First though I have a couple of questions. First what is CN9 for? Since its looks to be a 3.3 volt connection in the 3.3 volt subsystem I'm not populating it. Sj2 looks to be a solder short but its all ready shorted so I'm disregarding it. Lastly j2.. guessing an audio connection. If any of these are required let me know. Thx... :coffee:
Re: H5 A5 BOM (or lack of)
Posted: 05 Nov 2020 00:12
by exxos
If they are not listed in the jumper thread then you should do nothing and ignore them for now..
Re: H5 A5 BOM (or lack of)
Posted: 15 Nov 2020 13:08
by olivier.jan
Hi, after seeing that B1 rev is coming, I decided to try to get my A3 up before the first B1 arrives, I’m halfway through now and was wondering about Y1 as this crystal is not part of the BOM but is clearly visible on the H5 silkscreen, and it seems to be required by the MFP.
I got one from donor machine anyway, but wanted to know before soldering it.
Re: H5 A5 BOM (or lack of)
Posted: 15 Nov 2020 13:11
by PhilC
@olivier.jan yes its the 2ish mhz one that's used by the MFP so a donor from an existing board is perfect.
Re: H5 A5 BOM (or lack of)
Posted: 07 Aug 2021 16:12
by DoG
I can't remember but the battery(holder) is CR1220, right?
Re: H5 A5 BOM (or lack of)
Posted: 07 Aug 2021 16:18
by PhilC
DoG wrote: 07 Aug 2021 16:12
I can't remember but the battery(holder) is CR1220, right?
Yes that's right.
Re: H5 A5 BOM (or lack of)
Posted: 07 Aug 2021 16:21
by DoG
PhilC wrote: 07 Aug 2021 16:18
DoG wrote: 07 Aug 2021 16:12
I can't remember but the battery(holder) is CR1220, right?
Yes that's right.
Thx for that. I clearly wasn't reading the first post since exxos specified in the Mouser list a holder that is 1220. :oops: :roll: