exxos's Atari, Amiga & retro forum

Hey up !
I'm still playing with my ST.
I've just purchased a VGA adapter from this excellent web forum.
Has anyone 3d printed a case for it!
Thanks!

BeigeFM wrote: 29 Jan 2024 07:07 Hey up !
I'm still playing with my ST.
I've just purchased a VGA adapter from this excellent web forum.
Has anyone 3d printed a case for it!
Thanks!

There are a couple of different designs of the ST/VGA adapter, but there are a couple of threads over on the 3D models section for the low cost variant: viewtopic.php?f=62&t=3037

BW

You have this one too:

https://www.thingiverse.com/thing:3012676

Hey Chaps!

I have to admit I was being a little bit lazy when I posted the ST2VGA question. (I could of googled it!)

Currently printing an USB Power Cart case and I was like "Oh yeah! I bought the ST2VGA :) " and found myself back on this excellent forum!

Thanks for the STL's :) Happy days!

Id love to 3D Print a clip on trunking that runs down the back of the ST to hide the usb cable that powers the SD4ST.
Its just flopping around on top. (Cable runs from left to right)

Anyway, its been a while so Id better go post something else !

G

Ive just printed this btw

https://www.thingiverse.com/thing:3939170

Its too big for my usb cart which seems to have a shorter edge connector.
Ive just tried cutting the print back with a hot blade but its still too chunky to allow my board anywhere near the cartridge slot.

Another 3d print in the bin! (its been happening for years :D Im used to it :( )

I dont suppose you would know of any other usb cart stl's?

Mine is a ZibiLabs Rev B USBPwrCart - It could just be some ebay brand that makes no difference...

This looks like it will fit perfectly, but very pricey for a 10 min 3d print.

https://retroready.one/products/atari-s ... wer-source