exxos's Atari, Amiga & retro forum

Have a TF1260 with 060 rev.6, OS32.2.2.1 , 3.2.2Roms , MMULib installed.

Get software failure when booting, but when i double mouse and uncheck Update Rom Modules in Boot Options, boot is ok.
(some boots still get sw-failures or just a grey or black screen)
But when it starts i can only use PAL modes or no picture unless i also select Double Pal in Display Options (double mouse)

No issues with my old PPC/040 accelerator.

Anyone else had this issue?

Also Chip ram writes is only 3,5MB/s. Get 4,5MB/s with old 040 which makes it faster with C2P.

Anyone tested Chip ram access with TF1260 installed.

Current firmware version: Alpha 1000 (December 2021)

You should get 7Mb/s at 50Mhz. I've not tried that exact OS version. Could be related to your screen mode. Try it at lores 4 colour mode.

Its at Hires Pal 640x256 8bpl. Getting 4,5MB/s with old 040 accelerator.

runecbx wrote: 07 Aug 2023 23:28 Its at Hires Pal 640x256 8bpl. Getting 4,5MB/s with old 040 accelerator.

Yup but at that res 3.5Mb is all you will get from the TF i believe.