3-D printer infill oddity ?
Posted: 14 Feb 2022 22:36
Does anyone understand why this happens ?
I am just using the fast honeycomb infill (But is irrelevant it seems which one I use) Where I have a wall thickness of 5 layers.. But when it does the honeycomb fill it also does the lines I point to ?!
So why doesn't the infill just extend further instead of messing about with that tiny squiggle line ?!
I am using simplified 3-D, but I also see the same after installing Cura.
I am just using the fast honeycomb infill (But is irrelevant it seems which one I use) Where I have a wall thickness of 5 layers.. But when it does the honeycomb fill it also does the lines I point to ?!
So why doesn't the infill just extend further instead of messing about with that tiny squiggle line ?!
I am using simplified 3-D, but I also see the same after installing Cura.