Page 1 of 3
Icky's H5 C1 Build
Posted: 15 Jul 2021 12:45
by Icky
Board arrived today. A few mods needed (jumper removal) to use the Phoenix Shifter
IMG_0342.png
Re: Icky's H5 C1 Build
Posted: 28 Jul 2021 08:06
by Icky
Still no progress. Just like @rubber_jonnie I am currently going through house move madness and am packing things up trying desperately to leave the Atari workshop till last. It may have to go in storage for a little while.
Re: Icky's H5 C1 Build
Posted: 28 Jul 2021 08:10
by JezC
@Icky Shame! Hope all goes smoothly & you get relocated and the workshop back up & operational very soon!
Re: Icky's H5 C1 Build
Posted: 28 Jul 2021 09:25
by Icky
JezC wrote: 28 Jul 2021 08:10
@Icky Shame! Hope all goes smoothly & you get relocated and the workshop back up & operational very soon!
Thanks
@JezC - am hoping to have a considerably larger workshop after the move. :)
Re: Icky's H5 C1 Build
Posted: 28 Jul 2021 10:14
by PhilC
@Icky followed by a considerably larger 3d printer too perhaps?
Re: Icky's H5 C1 Build
Posted: 28 Jul 2021 11:17
by JezC
@PhilC @Icky Do we start choosing a name for "Son of Giant Panda" then?
:D
Re: Icky's H5 C1 Build
Posted: 28 Jul 2021 11:18
by PhilC
@JezC How about Revenge of the Giant Panda?
Re: Icky's H5 C1 Build
Posted: 28 Jul 2021 15:53
by Icky
@PhilC @JezC - my other 3D printer is already called the Red Panda -
https://www.exxosforum.co.uk/forum/viewt ... 175#p28175
Re: Icky's H5 C1 Build
Posted: 28 Jul 2021 16:48
by JezC
@PhilC @Icky Dread Panda?
Re: Icky's H5 C1 Build
Posted: 28 Jul 2021 20:17
by Darklord
Panzilla! :)