Page 1 of 19
TF Riser Revision 0 Arrives
Posted: 15 Jan 2020 15:44
by terriblefire
Boards are here.
IMG_1645.jpg
Keeping in mind that I dont have a firmware for the ARM... Who was after one to help out with dev?
Re: A new riser?
Posted: 15 Jan 2020 18:36
by arkadiusz.makarenko
I would like to buy one, please.
PS.
I am staring to look at this :
https://www.st.com/resource/en/user_man ... 105256.pdf
I have only boards with f103 which do not have required USB OTG. Any day now I should get f407 dev board, and I will be able to start looking at this properly. Meanwhile I am getting used to CubeIDE,HAL libraries and brilliant debbuging options via ST-Link
Re: A new riser?
Posted: 15 Jan 2020 19:33
by terriblefire
arkadiusz.makarenko wrote: 15 Jan 2020 18:36
I would like to buy one, please.
PS.
I am staring to look at this :
https://www.st.com/resource/en/user_man ... 105256.pdf
I have only boards with f103 which do not have required USB OTG. Any day now I should get f407 dev board, and I will be able to start looking at this properly. Meanwhile I am getting used to CubeIDE,HAL libraries and brilliant debbuging options via ST-Link
I'll slip a board in with your TF536.
Re: A new riser?
Posted: 15 Jan 2020 20:12
by arkadiusz.makarenko
Great thank you.
Re: A new riser?
Posted: 16 Jan 2020 21:40
by terriblefire
Started the build...
IMG_1650.jpg
Waiting for the ARM cpu tomorrow.
One thing to note is that the MCA connector needed the tabs trimmed off to fit due to the way my MCA connector tabs are.
EDIT: I actually think it will be far easier to develop on this board than a dev board.
Re: A new riser?
Posted: 16 Jan 2020 22:07
by arananet
looks great S.
Re: TF Riser Revision 0 Arrives
Posted: 17 Jan 2020 11:55
by bprepared
Watching this with great interest and anticipation, particularly with regards to the ARM HID USB part :D
Re: TF Riser Revision 0 Arrives
Posted: 17 Jan 2020 12:26
by terriblefire
bprepared wrote: 17 Jan 2020 11:55
Watching this with great interest and anticipation, particularly with regards to the ARM HID USB part :D
You are welcome to rework/integrate your changes to the video system if you want. Spare board for you if you want
Re: TF Riser Revision 0 Arrives
Posted: 17 Jan 2020 15:43
by bprepared
Thanks, would appreciate the board for sure, and if/when the ARM USB and RTC is working I'd like to try and integrate (with full credits to all parties) them onto a Firebird module, maybe even a Notport. ;)
PM inbound with address.
Re: TF Riser Revision 0 Arrives
Posted: 17 Jan 2020 21:44
by wairnair
So, it is happening. Amazing.