exxos's Atari, Amiga & retro forum

Hi all,

I have an A500+ with a Rev 8A.1 Motherboard, and have taken my time ( too much ) fixing battery damage, The CAP C12 didn't make it, and I can't remember what it ism looking at amigapcb.org shows as a 10uF , now can I use a standard ceramic cap, or does it need to be "mlcc" ??
Also need to find a supplier of 74LS244 as managed to order some ages ago and they are now lost in the depths of my cave !
I have re-capped it, is there anything else I should replace while I'm in there ?

Thanks
Simon

Hi,

Looking good. :thumbup:
Cap C12 = 10nF (nanofarad) and is the same as C10.

But you should be good to post it with out c12.

Justme14 wrote: 16 Jul 2019 06:52 Hi,

Looking good. :thumbup:
Cap C12 = 10nF (nanofarad) and is the same as C10.

But you should be good to post it with out c12.

Thanks very much

Good to know I would get away without it as well :)