exxos's Atari, Amiga & retro forum

exxos wrote: 03 May 2019 17:43

Icky wrote: 03 May 2019 17:41 Been doing the same but fell at the first hurdle. I could not find my old skool tools.

Took me a while to find my track cutter :lol:

Exactly - that's what I am still hunting. I think the office is now upside down (not that you could tell as its a mess always anyway).

Icky wrote: 03 May 2019 17:47 Exactly - that's what I am still hunting. I think the office is now upside down (not that you could tell as its a mess always anyway).

5mm drill bit ;)

exxos wrote: 03 May 2019 17:50

Icky wrote: 03 May 2019 17:47 Exactly - that's what I am still hunting. I think the office is now upside down (not that you could tell as its a mess always anyway).

5mm drill bit ;)

Yeah - I was trying to avoid going out to the garage as its raining. Oh well - time to get wet.

Now to figure out how to wire this thing in :lol:

exxos wrote: 03 May 2019 17:56 Now to figure out how to wire this thing in :lol:

I have forgotten how much I hate these boards. :evil:

So mine is done, but long story short, it is unstable as hell :cry:

It will only even attempt to boot with a IMP chipset... I have removed the blitter, and tried a few things, but only seem to make it worse :(

It is one of those things that it may be possible to get working stable at if a lot of time is spent on it, but if we spend a lot of time on this, other projects are not getting finished :roll:

I don't have any more time tonight, and may have a play around with it a little more on Monday, but I think it will be better spending time on getting the FPGA cores up and running.

Is it worth you trying the SMT MMU and GLUE?

Muahahaha :D :D :D :D :smoke:

For some reason I had R150 pulled out causing I assume no pull up on BGACK.. That should have been fixed by a resistor mod, unless the wire came off...So that was causing the floppy drive to go not in all sorts of chaos..

Also the 74F04 chip which I used as the 32MHz & 16MHz buffer, seriously sucks :roll: I rooted the oscillator directly to the shifter and MMU and it now seems pretty stable, before I could not even get to the desktop..

I have also currently got a -38 MMU in place (I had removed the IMP one) I don't know if this was a factor or not, but I dare not touch anything while it is working :lol:

nice

Does make you wonder why nobody at Atari did this back in the day.