exxos's Atari, Amiga & retro forum

PaulJ wrote: 16 Nov 2018 15:16 This is what happens when developers are turned loose to develop in an area with no zoning laws. Complete chaos!! If I'm going to use my ultra satan and the 1772 buffer card I figure I will need 12 sockets to clear the ultra satan connector card. Where will it end! :) :) :)

• PSU recapped and re-filmed (metal film resistors replaced) - this was the PSU that had the smelly / hot resistor - https://www.exxosforum.co.uk/forum/viewt ... f=9&t=1327
• Smonson's HDMI / DVI Board - trying this out on the board as it's easier to get to and work on than my STM - https://www.exxosforum.co.uk/forum/viewt ... 260#p14292

exxos wrote: 24 Nov 2018 14:06 :bravo:


When it looks like this, our work is done.


46520103_1926144830800878_2092118341278760960_n.jpg

Icky wrote: 24 Nov 2018 14:08

exxos wrote: 24 Nov 2018 14:06 :bravo:


When it looks like this, our work is done.


46520103_1926144830800878_2092118341278760960_n.jpg

That looks too structured and neat for when we have finished. Wait till you see the IDE test board strapped to the STF Remake. Thinking I may have to build breadboard shelves :D

PaulJ wrote: 24 Nov 2018 14:12

Icky wrote: 24 Nov 2018 14:08

That looks too structured and neat for when we have finished. Wait till you see the IDE test board strapped to the STF Remake. Thinking I may have to build breadboard shelves :D

Is that an un-fu*kit drawer on the top of the rack? Its the predecessor to the un-fu*kit board! :cheer: :cheer: :cheer:

Icky wrote: 25 Nov 2018 09:15

PaulJ wrote: 24 Nov 2018 14:12

Is that an un-fu*kit drawer on the top of the rack? Its the predecessor to the un-fu*kit board! :cheer: :cheer: :cheer:

I just spotted the rack on the left sporting the two large PSU's I wonder if Exxos does a recap kit for those.

Icky wrote: 27 Nov 2018 13:37 I think Exxos won't be happy until my PSU is standing at least a foot above the board.