exxos's Atari, Amiga & retro forum

Dwh18 wrote: 07 Mar 2025 22:08 Did some more digging and noticed u35 and u32 are different than U36 and U33. Is this supposed to be like this?

olivier.jan wrote: 08 Mar 2025 07:12 The adapter you have should work, what I was mentioning are the little usb to serial (not RS232) like this: https://amzn.eu/d/dCjUFvn.

Anyway, if you want to check : Pin 8 of the MFP is TX while pin 9 is RX. So, if the diag cart is sending dat, you should see activity on pin 8 when you start the ST. You can test also the other direction: if you type data in your serial terminal it should generate activity on pin 9 of the MFP.

If you have an oscilloscope, checking will be pretty easy. With a multimeter, set on DC, you should see some voltage variations when there is activity.

rubber_jonnie wrote: 08 Mar 2025 08:04 When things run on for a bit, I always like to suggest a summary of where you're at now, for example:

What are the current symptoms?
What do you see when you boot without a diag cart?
What do you see when you boot with a diag cart? How much RAM is indicated when the diag cart does eventually load?
What do you see over serial when you boot with a diag cart
What are the measured voltages when on load?

When considering the symptoms, are you booting in HiRes? If so try booting in low/med res as it will show a border that you don't see in HiRes.

When threads get long it makes it easier for people reading to pick up rather than going back over 6 pages of posts.

Plus it's always good to have a checkpoint and verify what you've done so far for your own sanity.

I'd suggest if you can to take a photo of the area you reverted so that we can review what you've done, not because we think you've done something wrong necessarily, but because a 2nd pair of eyes is always helpful.

rubber_jonnie wrote: 08 Mar 2025 16:51 No problem, help is what we try to do well here :)

Given you say voltages are not tested, I'd suggest you just check 5v and 12v are good, though 5v should be enough to boot.

When you say white then black when booting in lo res, do you mean the whole screen is white then the whole screen goes black, or do you mean the whole screen goes white and then you get a black screen with a white border?

It might seem like there isn't a difference, but there is a difference.

I'd think you're getting a black screen with a white border, it it's worthwhile being sure. That generally means no RAM.

BTW I assume the black wire is just the fix for the bad track? I'd also suggest you have a look at the resistors, they could do with a little more solder in the vias. I've had bad vias before that were ok so long as they were filled with solder, and not all of yours are.

Given it seems probable that there is a RAM issue, I'd suggest you should have a look at the power to the RAM IC's and also look at RAS/CAS and address/data lines on the RAM, though I don't know if you have an oscilloscope.

It seems to me that it's booting, but when it comes to start it can't find the RAM. I think this may be why the cart works but not the machine, and possibly why the cart boot takes a long time.

Dwh18 wrote: 10 Mar 2025 20:41 Low - White for 3s then black screen

rubber_jonnie wrote: 11 Mar 2025 08:30

Dwh18 wrote: 10 Mar 2025 20:41 Low - White for 3s then black screen

So is it a completely black screen or a black screen with a white border?

@stephen_usher is right about the the red screen.