Page 5 of 7
Re: A future project - Science Of Cambridge MK14
Posted: 27 Jul 2024 00:49
by HigashiJun
Re: A future project - Science Of Cambridge MK14
Posted: 27 Jul 2024 07:35
by rubber_jonnie
Re: Science Of Cambridge MK14 Replica build
Posted: 27 Jul 2024 08:03
by HigashiJun
Good to hear that !
I had a Traco in my Oric Atmos and it was night and day compared to the old and burning hot LM.
8-)
Re: Science Of Cambridge MK14 Replica build
Posted: 27 Jul 2024 08:11
by PhilC
Out of interest, which traco do you guys use? A lot of the 7805 equivalents only do 0.5 - 1.0 amp which is fine for a spectrum but not for other stuff.
Re: Science Of Cambridge MK14 Replica build
Posted: 27 Jul 2024 09:03
by HigashiJun
PhilC wrote: 27 Jul 2024 08:11
Out of interest, which traco do you guys use? A lot of the 7805 equivalents only do 0.5 - 1.0 amp which is fine for a spectrum but not for other stuff.
I had a TSN 1-2450A in my Atmos.
And yes, it was 1 amp.
Re: Science Of Cambridge MK14 Replica build
Posted: 27 Jul 2024 09:47
by PhilC
Thanks @HigashiJun
Re: Science Of Cambridge MK14 Replica build
Posted: 27 Jul 2024 10:18
by rubber_jonnie
The one I've ordered is 1 amp, the Mk14 takes around 1/2 amp.
TSR 1-2450A
Re: Science Of Cambridge MK14 Replica build
Posted: 03 Aug 2024 09:10
by rubber_jonnie
So, the Traco is installed in the MK14 now:
IMG20240802100430.jpg
And the thermals look good:
20240802-135305.jpg
The Traco is running at 39.4C and the item at 56.6C in front of it is one of the two Tesla PROMs holding the SCIOS operating system. With the 7805 installed with a large heatsink I was getting about double the temp of the Traco, and also I'm pulling about 100mA less with the Traco too, so definitely a good call to swap it out.
Re: Science Of Cambridge MK14 Replica build
Posted: 03 Aug 2024 09:49
by stephen_usher
I would put an oscilloscope on the +5V rail as these switching DC-DC converters may produce ripple.
Re: Science Of Cambridge MK14 Replica build
Posted: 03 Aug 2024 10:21
by rubber_jonnie
stephen_usher wrote: 03 Aug 2024 09:49
I would put an oscilloscope on the +5V rail as these switching DC-DC converters may produce ripple.
Maybe later on, just at the barbers for a trim 😁
EDIT - I'm seeing a mean ripple value of about 15mV, probably helps having a 1000uF capacitor on the input side.