Page 5 of 13
Re: REV H1 information and interest
Posted: 22 May 2019 22:51
by exxos
JezC wrote: 22 May 2019 22:45
Might only be 24 as PhilC == Forgottenmyname...?
ah yes, good catch. deleted one.
Re: REV H1 information and interest
Posted: 22 May 2019 23:36
by Anzac
With currency conversion £80 is a bit steep for me, but since I don't want the hardware, I can pledge £60 :)
Re: REV H1 information and interest
Posted: 22 May 2019 23:56
by exxos
you get charged £40 for conversion ?!
Re: REV H1 information and interest
Posted: 23 May 2019 07:14
by Anzac
No, it's just the difference between currencies.
£60 is 71€ for me, plus paypal fees to send the money, final cost should be around 75€.
So, yeah, maybe I can go a little more, but if I go for £80 it gets real close to 100€ and that makes a difference for me...
I have always tried to support developers and the community, sometimes just by donating in recognition of the work that had been done
I understand that my offer here isn't much and later I'll support the project again if needed, right now, this is what I can do..
Re: REV H1 information and interest
Posted: 23 May 2019 16:30
by exxos
I have a
donate button for such payments anyway. Where people just type in the amount they want to donate..
Though I don't use paypal anymore. So its done on credit card. I get charged "non sterling transaction charge" when I do overseas payments, but its normally only about £2 or thereabouts.. of course I don't know what the charges are for other banks..But if the charges are crazy, then I probably suggest just not bothering.
Re: REV H1 information and interest
Posted: 23 May 2019 20:57
by Icky
Have been helping out with some of the routing on the H2. This is the MMU - PLCC and SMT.
Screenshot 2019-05-23 at 20.54.30.png
Re: REV H1 information and interest
Posted: 23 May 2019 21:04
by exxos
Looking good! Saving me a lot of torment with not having to click things all day!
:thanksyellow:
Re: REV H1 information and interest
Posted: 25 May 2019 20:25
by Icky
One stripped ST motherboard for exxos to use as a template to check the holes and other dimensions for correct placement on the next Remake board.
This was the broken motherboard that was used as the donor for my STF Remake so did not take too long to strip everything off.
1B49055E-CBE9-4134-8368-350E53176ECA.jpeg
Re: REV H1 information and interest
Posted: 25 May 2019 21:08
by exxos
Thing of beauty... should put it in the motherboard section :)
Re: REV H1 information and interest
Posted: 25 May 2019 22:26
by Icky
exxos wrote: 25 May 2019 21:08
Thing of beauty... should put it in the motherboard section :)
Yes even though it has a few ripped tracks, partial reason the motherboard was dead, and is not perfectly flat it is something to behold.
I’ll drop the pic into the motherboard section :)