Page 4 of 4
Re: Xilinx programming cable USB -- anyone got this one?
Posted: 26 May 2022 10:44
by frank.lukas
Badwolf wrote: 25 May 2022 21:28
What is your USB VID/PID pair now?
... the same as before!
usb_xilinx.jpg
Re: Xilinx programming cable USB -- anyone got this one?
Posted: 26 May 2022 13:36
by Badwolf
frank.lukas wrote: 26 May 2022 10:44
Badwolf wrote: 25 May 2022 21:28
What is your USB VID/PID pair now?
... the same as before!
That's a shame. I was hoping if it had now been programmed by Impact it could be used with xc3prog. Never mind, if you have a working setup, we can at least try things. :-)
BW
Re: Xilinx programming cable USB -- anyone got this one?
Posted: 26 May 2022 18:15
by frank.lukas
Someone over the Atari-home forum told me the driver is "xpc" but it not work correct with xc3sprog. Same can you read at the web.
Impact works fine ...
Xilinx_Suite.jpg
Re: Xilinx programming cable USB -- anyone got this one?
Posted: 30 May 2022 15:45
by Steve
Hi Frank,
I believe your TT ram problem might only require re-flowing the solder on your ram chips and ram buffer chips.
I finished building a DFB1 today and it would not detect the ram even though I thought it was soldered perfectly. I put flux over and re-flowed and now it is all working.
PXL_20220530_142956767.MP.jpg
PXL_20220530_142727237.jpg
PXL_20220530_142724182.jpg
Re: Xilinx programming cable USB -- anyone got this one?
Posted: 30 May 2022 17:10
by Badwolf
Steve wrote: 30 May 2022 15:45
Hi Frank,
I believe your TT ram problem might only require re-flowing the solder on your ram chips and ram buffer chips.
Great to see another board firing on all cylinders, Steve!
I'm starting to wonder if
@frank.lukas's problem is indeed a solder joint or similar that's vibrated loose in shipping as there does seem to be a time (which to me impies heat) dependence to it.
It's all very odd.
Hopefully we'll get there.
BW