exxos's Atari, Amiga & retro forum

@exxos Probably in a week or so...need payday to arrive first!

Would be great if you can add that to the next order...but I can wait longer if necessary.

Almost finished soldering up a minimal H5C1 build... :roll:

where is jp13 on the h5 c1? it's not where it says it is on the image, or is that for h4?

alienkidmj12 wrote: 11 Aug 2021 08:14 where is jp13 on the h5 c1 ? its not where it says it is on the image, or is that for h4 ?

The image shows where the green wire goes ..

https://www.exxosforum.co.uk/forum/viewt ... 730#p54885

i see it, it's not there is actually a bit higher up,

Sorry if I missed it, but do I need to hook up IRQ for Trudie to work on a stock ST?

Steve wrote: 21 Aug 2021 21:18 Sorry if I missed it, but do I need to hook up IRQ for Trudie to work on a stock ST?

IRQ is still needed on all machines.

Steve wrote: 21 Aug 2021 21:18 Sorry if I missed it, but do I need to hook up IRQ for Trudie to work on a stock ST?

exxos wrote: 21 Aug 2021 23:32 IRQ is still needed on all machines.

@Steve the pic below shows the easiest way to hook it up on an H4/5

And on a stock ST? Where would I find IRQ? Thx

Steve wrote: 22 Aug 2021 11:27 And on a stock ST? Where would I find IRQ? Thx

Pick it up from the inside of the ACSI socket perhaps Steve?

Pin 10 on ACSI connector.

EDIT: It goes to a 74LS04 on the board.