exxos's Atari, Amiga & retro forum

IngoQ wrote: 08 Dec 2019 17:19 Finally I found some time to start soldering. I managed to finish the Reset circuit, composite gen, mono gen, audio gen, DAC circuit and RGB/Mono switch:

I believe you should take a gander at cr14. Looks like it maybe in backwards. :)

@PaulJ - you must have the eyes of a hawk. Well spotted.

Icky wrote: 15 Dec 2019 21:24 @PaulJ - you must have the eyes of a hawk. Well spotted.

Don't know, that kinda thing just reaches out and slaps me. :dizzy:

PaulJ wrote: 15 Dec 2019 21:14 I believe you should take a gander at cr14. Looks like it maybe in backwards. :)

@PaulJ Wow, thanks! You probably saved me hours of looking for that one :)

Which motivates me to upload better pictures of my progress, you never know if someone is nice enough to have a look at them :mrgreen:

@IngoQ when people post pictures I usually look for obvious mistakes, @PhilC usually makes em easy to spot like putting the reset chip in perpendicular to its intended position.
:dizzy: :dizzy: :dizzy:

@PaulJ I was just keeping you on your toes us all.

I know @PhilC , you did throw in the backward diode in addition to the reset chip. You thought you could sneak that one in figuring I'd give up after the reset find. :mrgreen: :mrgreen: :mrgreen:

Happy to help Paul

My back is getting better, so I here is some progress:
All sockets in place, only some of the resistors are missing, and then on to the fixes. I'm positive I get it finished this year :mrgreen:

:cheer: :cheer: :cheer: :bravo: