exxos's Atari, Amiga & retro forum

Another pink prototype print, this time of the removable back panel. One way or another @exxos will get his pink case :)

A few tweaks on the bottom case part and hopefully print out that in the next few days.

:excited: :excited: :excited: :excited: :excited: :thumbup: :thumbup:

Edit:
No need for RF hole though ;)

exxos wrote: 02 Aug 2020 00:29 No need for RF hole though ;)

Yep - That’s the great thing we can now have whatever we want on there as different slot in options :)

I Just noticed we need to add on the port icons as well.

Icky wrote: 02 Aug 2020 00:34 Yep - That’s the great thing we can now have whatever we want on there as different slot in options :)

I Just noticed we need to add on the port icons as well.

Oh yep.. Plus logo ;). Though icons should be easier now the back is flat printed :)

This is superb work, niiiiice job!

Transparent would look so cool, is that even possible though?

shintek wrote: 02 Aug 2020 03:22 Transparent would look so cool, is that even possible though?

@shintek - I did look into clear ABS a while back for a different project and most always ends up opaque or frosted. There was one reporting to be truly clear but it was about £50 a reel so didn't fork out to see if it worked or not.

@Icky Nice job :) Can't wait to see the full case

Started on the text for rear panel and then need to do the icons. Will have to see how it actually comes out on the print.

Just playing around with some more printed parts. Not the best of keyboards its a defunct one. Just need a few tweaks, very minor adjustments. e.g. 1 mm extra on the function key aperture lengthways and width ways as its a little tight.