Page 3 of 3
Re: Fixing and upgrading an Enterprise 64
Posted: 06 Aug 2026 16:44
by stephen_usher
If you used PLA it may start to deform as that heatsink gets very toasty, above the PLA glass temperature. PET-G *may* have enough thermal headroom.
Re: Fixing and upgrading an Enterprise 64
Posted: 06 Aug 2026 16:54
by PhilC
stephen_usher wrote: 06 Aug 2026 16:44
If you used PLA it may start to deform as that heatsink gets very toasty, above the PLA glass temperature. PET-G *may* have enough thermal headroom.
Fortunately I was already thinking the same and used PET-G :)
Re: Fixing and upgrading an Enterprise 64
Posted: 16 Aug 2026 16:46
by PhilC
I've just got the floppy interface assembled.
- PXL_20260816_154233719.jpg (268.34 KiB) Viewed 53 times
next it's time to sort out the external floppy drive. It's a dual 3.5" drive that I also use on a QL. Just got to swap out one of the drives for a gotek and then we're good to go.
Re: Fixing and upgrading an Enterprise 64
Posted: 16 Aug 2026 16:57
by rubber_jonnie
PhilC wrote: 16 Aug 2026 16:46
I've just got the floppy interface assembled.
PXL_20260816_154233719.jpg
next it's time to sort out the external floppy drive. It's a dual 3.5" drive that I also use on a QL. Just got to swap out one of the drives for a gotek and then we're good to go.
Nice :)