exxos's Atari, Amiga & retro forum

:bravo: Another faulty via was it @PhilC :lol: :chairsmack:

exxos wrote: 05 Nov 2020 20:35 :bravo: Another faulty via was it @PhilC :lol: :chairsmack:

Well if it wasn't, I'm not sure where the RW had gone to :lol:

Happy it works now

Hey Phil is this a fix everyone needs to do or just limited to your particular board?

Steve wrote: 06 Nov 2020 18:02 Hey Phil is this a fix everyone needs to do or just limited to your particular board?

Looks like its just my board so far Steve.

PhilC wrote: 05 Nov 2020 20:32 RW on the shifter has a fault on the pcb, I fitted a bodge wire from pin 9 on IO port 1 to pin 31 on the shifter and were all up and running, so no wonder things were confused.

@PhilC - That RW route to the shifter comes from IC6 and is where FIX #2 is required. Is there a possibaility the RW line got damaged during the fix or is it a quality issue on the board? The RW route is on the bottom layer so you should be able to see any damage.

Purple line RW route

@Icky I did think that at first but I'm not guilty of any breakage this time, only fixage :D

PhilC wrote: 06 Nov 2020 18:59 @Icky I did think that at first but I'm not guilty of any breakage this time, only fixage :D

I didn't think you would :)

@Icky well I did have to go through the fixes a good half dozen times before I was sure it wasn't my fault. :lol: