exxos's Atari, Amiga & retro forum

Everyone is a witness...

Isn't all the fault due to drill distance? Vias or mounting holes intersecting tracks?

EDIT: Should say overlap instead. Hmm...

EDIT2: But you run EAGLE 7 or something?

Aah. Drill distance is when two hole are to close to each other. Vias and holes. Never mind then.

DoG wrote: 29 Oct 2020 22:02 Aah. Drill distance is when two hole are to close to each other. Vias and holes. Never mind then.

It was "overlaps" where the problems all were. I was using Eagle 7 and Eagle 9 to check DRC errors.

All I did was move the S2 header, now its magically got 43 wire stubs from before... This is what I mean about Eagle, stuff just doesn't work right :headbang:



EDIT:

Did all those, then ran DRC again, it found another 4 :roll: Did those then found another 2.. Ran DRC serveral times.. nothing..

Restarted Eagle and...

exxos wrote: 29 Oct 2020 23:18 This is what I mean about Eagle, stuff just doesn't work right :headbang:

The metaphorical smack on the arse by the midwife that is Eagle, delivering a bouncing baby KiCAD user? ;)

BW.