exxos's Atari, Amiga & retro forum

Posted: **28 Aug 2020 17:52**

qq1975b wrote: 28 Aug 2020 17:11 Thank you. Solved. I had to adjust the Red and Green Cut Off regulators. The Red and Green Drive regulator didn't correct the problem but the Cut Off regulator (next to the others), yes.

Thanks again for the help.

Great! I'll be recapping a few SC1224s in the coming months so this will help me too.

Posted: **19 Nov 2024 18:19**

Hi all,
I have an SC1224 and I am looking to do the adjustment on the vertical alignment (vertical centre) as it's too low currently, but I cannot see R626 on the PCB or anywhere else...

It's a Goldstar with a Hitachi screen, and it has Atari printed on the bezel, but not on a badge of any type. I wondered if anyone can help me locate this?

Thanks,
Paul

Posted: **20 Dec 2024 15:09**

Those old monitors can be tricky to recalibrate after replacing capacitors. Nice work on figuring out the exact adjustments needed.

Posted: **20 Dec 2024 20:56**

cawley1 wrote: 19 Nov 2024 18:19 Hi all,
I have an SC1224 and I am looking to do the adjustment on the vertical alignment (vertical centre) as it's too low currently, but I cannot see R626 on the PCB or anywhere else...

It's a Goldstar with a Hitachi screen, and it has Atari printed on the bezel, but not on a badge of any type. I wondered if anyone can help me locate this?

Thanks,
Paul

R626 is behind the on/off switch

exxos's Atari, Amiga & retro forum

Atari SC1224

Re: Atari SC1224

Re: Atari SC1224

Re: Atari SC1224

Re: Atari SC1224