exxos's Atari, Amiga & retro forum

dragmar wrote: 09 Jun 2020 09:43 IDE V1.1 R1C - LED 5V?

Do you also need to use PLD connections in this board?

Yes.

PCB solder. I put pictures, and I have a request, if I installed something wrong, I ask for information.

hi
is the parts list still current if fitting to an stfm.
cheers

philbo34 wrote: 27 Jun 2020 19:18 hi
is the parts list still current if fitting to an stfm.
cheers

No difference from a STFM to H4.

dragmar wrote: 10 Jun 2020 22:20 PCB solder. I put pictures, and I have a request, if I installed something wrong, I ask for information.

@dragmar - I can't see anything out of place from the photos at first glance.

Do you have the ACSI_10 header pin soldered in. I could not see it from the photo. Its the one to the top left of the large PLD.

forgive the prob stupid questions
are the resistors 1/4 watt
what type are the majority of the caps .
cheers

philbo34 wrote: 04 Aug 2020 05:26 forgive the prob stupid questions
are the resistors 1/4 watt
what type are the majority of the caps .
cheers

0.25 W is fine for the resistors. Everything except C8 are just little ceramic caps (at least on my build), and C8 is an electrolytic.

cheers for info

ivw ordered one of the bare boards just out of curiosity where would i get the image for the 27c4096 eprom or is it a matter of loading 1 image in low and other in hi space and is there anything i need to do to the roms?
looking forward to building and installing it into my stfm once i get it fixed

TOS images are here. https://www.exxosforum.co.uk/forum/viewt ... f=25&t=116 program 2 normally TOS104 TOS206 into it.