exxos's Atari, Amiga & retro forum

terriblefire wrote: 23 Jan 2019 09:10 Not sure. Doesn’t manage to read the first 4 words in rom correctly. So might be a solder issue

As a great man once said : "Clocks are the biggest problem for a non booting Diagrom, or just bad soldering."

S.J Leary, Youtube, December 2017 :)

This usually applies to board that has booted at least once... no such luck here.

ok it boots to DiagROM. Bad firmware was the issue.

terriblefire wrote: 24 Jan 2019 12:17 ok it boots to DiagROM. Bad firmware was the issue.

Great stuff! Looking forward to the next live stream!

If you want a fan holder, how about something like this? maybe locate the holes with maximum clearances available
if its too tall then maybe a 5015 blower fan off to the side

https://www.ebay.co.uk/itm/2Pcs-38mm-x- ... ctupt=true

https://www.ebay.co.uk/itm/5V-DuPont-35 ... ctupt=true

Thanks. Is there any clamps that are suitable available off the shelf? I just try to make it easy whereever i can.

Also I broke the TF534.. well the IDE... no idea what i did.

terriblefire wrote: 24 Jan 2019 22:15 Also I broke the TF534.. well the IDE... no idea what i did.

You mean that you have no IDEa? Sorry.

kludge wrote: 24 Jan 2019 22:59 You mean that you have no IDEa? Sorry.

:bravo: :lol:

So it turns out that the problem was a duff IDE cable. Probably caused by me using it as a jig while soldering.

So... It sounds like this will be released soon-ish. If I wanded to begin the hunt for components for the TF534; what are the specs for the CPLDs and RAM?