exxos's Atari, Amiga & retro forum

@exxos I think we need an underpants emoji for these such scenarios. That really is pants the whole lot was assembled incorrectly.

Icky wrote: 14 Dec 2021 10:02 @exxos I think we need an underpants emoji for these such scenarios. That really is pants the whole lot was assembled incorrectly.

:clown:

exxos wrote: 14 Dec 2021 10:34

Icky wrote: 14 Dec 2021 10:02 @exxos I think we need an underpants emoji for these such scenarios. That really is pants the whole lot was assembled incorrectly.

:clown:

You deployed the clown :D

Icky wrote: 14 Dec 2021 10:41

exxos wrote: 14 Dec 2021 10:34

:clown:

You deployed the clown :D

I tried squinting to see if the clown looked like underpants, but no.......

rubber_jonnie wrote: 14 Dec 2021 11:28 I tried squinting to see if the clown looked like underpants, but no.......

exxos wrote: 14 Dec 2021 11:47

rubber_jonnie wrote: 14 Dec 2021 11:28 I tried squinting to see if the clown looked like underpants, but no.......

BMlZHfBCQAApMl-.jpg

:lol:

CPU PCB relocators comes. Bit of a tight fit but should just all fit...

A little bit "too" close :lol: But it works and fits so I don't really care :) As to if the booster fits or not is yet to be seen.


EDIT:

Sits higher than it would if the 2x 68K sockets are used (or 3x if the CPU was in a socket as well!)

My highly sophisticated programming and test setup...


Just waiting for the boards to come out of the ultrasonic cleaner currently :ball:

Having to keep pressing and pulling out the board was starting to really hurt my hands again :( so I had a better idea to use a ZIF socket. now things are moving along a lot faster and easier :dualthumbup: