Dammit! When using knives member to cut away from your fingers folks :roll: I got a good deep inch long cut in my finger :( Good job it was lengthways and not across!!
Capture.JPG
Now to go clean up the kitchen as it looks like a crime scene now :lol:
Re: exxos blog - random goings on
Posted: 23 Aug 2021 15:41
by exxos
As it was impossible to get the support in-fill out.. :roll: For the hell of it I just tried printing without it, and was amazed it wasn't a total disaster :o
IMG_6847.JPG
IMG_6848.JPG
Re: exxos blog - random goings on
Posted: 23 Aug 2021 15:54
by JezC
exxos wrote: 23 Aug 2021 13:46
Dammit! When using knives member to cut away from your fingers folks :roll: I got a good deep inch long cut in my finger :( Good job it was lengthways and not across!!
Now to go clean up the kitchen as it looks like a crime scene now :lol:
:awwww:
Ouch! Careful or you'll get a similar reputation to @rubber_jonnie and his (finger) soldering iron!
:hide: :poke:
Re: exxos blog - random goings on
Posted: 23 Aug 2021 16:02
by exxos
JezC wrote: 23 Aug 2021 15:54
:awwww:
Ouch! Careful or you'll get a similar reputation to @rubber_jonnie and his (finger) soldering iron!
My injuries I think are normally a lot worse, don't you remember my "eye" pictures from a while back :lol: :roll:
Re: exxos blog - random goings on
Posted: 23 Aug 2021 16:08
by JezC
exxos wrote: 23 Aug 2021 16:02
My injuries I think are normally a lot worse, don't you remember my "eye" pictures from a while back :lol: :roll:
I'd not seen those...very nasty! Just so long as the injuries don't halt you progress battling with those pesky printers!
exxos wrote: 23 Aug 2021 13:46
Dammit! When using knives member to cut away from your fingers folks :roll: I got a good deep inch long cut in my finger :( Good job it was lengthways and not across!!
Now to go clean up the kitchen as it looks like a crime scene now :lol:
:awwww:
Ouch! Careful or you'll get a similar reputation to @rubber_jonnie and his (finger) soldering iron!
:hide: :poke:
I bet you run with scissors too......
Hope it isn't too bleedy.
Re: exxos blog - random goings on
Posted: 23 Aug 2021 17:14
by exxos
Has anyone come across this problem ?
When it is doing the internal infill, the change of direction from right to left seems to place down filament and ends up being a "blob" higher than the rest of the print layer..
I have tried changing the overlap between infill and parameters, extruded retraction, speeds up the print.. Nothing seems to do anything at all :(
Oddly on the left-hand side of the print it does not seem to have that problem.