Page 14 of 14
Re: Building a DIY large bed 3D printer
Posted: 13 Nov 2023 10:51
by rubber_jonnie
Icky wrote: 13 Nov 2023 10:42
rubber_jonnie wrote: 13 Nov 2023 10:36
A little disappointing to see that neither of your beverage conveyances are Phoenix mugs.
They are in the dish washer. Although this was a coffee and tea based beverage project.
Just don't let it happen again ;)
Re: Building a DIY large bed 3D printer
Posted: 13 Nov 2023 11:10
by Icky
rubber_jonnie wrote: 13 Nov 2023 10:51
Icky wrote: 13 Nov 2023 10:42
They are in the dish washer. Although this was a coffee and tea based beverage project.
Just don't let it happen again ;)
:2k2:
Re: Building a DIY large bed 3D printer
Posted: 01 Jan 2024 14:10
by Icky
Giant Panda printer is now rebuilt with the CNC aluminium parts but I have now had a controller board failure.
Ordered a new one over the holiday period but need to wait until tomorrow for them to ship.
Have gone a bit over kill on the new board with a Duet 3 Mainboard 6HC including a Revo toolhead board (canbus) and new Revo hot end.
Hoping to get the printer back online in the next few weeks.