exxos's Atari, Amiga & retro forum

Yeah, just one would be enough. I might have to hone up my SMD soldering skills about 5 levels to put the CPU on there though! :-)

stephen_usher wrote: 28 Oct 2020 16:56 Yeah, just one would be enough. I might have to hone up my SMD soldering skills about 5 levels to put the CPU on there though! :-)

If you get one with bent pins then it'll take you forever to get everything lined up and soldered. Even with all the pins straight they are a pain to solder.

Noted. I'd have to use hot air on that scale of device.

I don't s'pose you know of a good source for them?

stephen_usher wrote: 28 Oct 2020 17:55 Noted. I'd have to use hot air on that scale of device.

I don't s'pose you know of a good source for them?

I believe exxos ordered them from Aliexpress.

Thanks... so pot luck then.

stephen_usher wrote: 28 Oct 2020 18:26 Thanks... so pot luck then.

I've built four and all four will run at 50mhz for at least two hours each but with a heatsink.

Is this the correct type? "MC68030FE33C MC68030 QFP-132"

stephen_usher wrote: 28 Oct 2020 18:45 Is this the correct type? "MC68030FE33C MC68030 QFP-132"

Sorry only just seen this post.. I got them from here.. https://www.aliexpress.com/item/4001034 ... 4c4dOptuSX but @PhilC said the pins were bent.

Got these in the UScleaner :)

exxos wrote: 03 Nov 2020 14:27 Got these in the UScleaner :)

:dualthumbup: