Page 2 of 2
Re: PHIHONG PSM-5341: blown (?) resistor R35
Posted: 10 Apr 2023 20:30
by exxos
wolfman wrote: 10 Apr 2023 19:44
Steve wrote: 10 Apr 2023 18:59
I have my Noctua in still, but I run it at the high speed setting.
Good to know: I planned to put the fan to the "middle" setting - but I think a Noctua fan is quiet enough running full speed.
@Steve is right. It's not a good idea to slow down PSU fans. I'm not sure what the airflow is of the Noctua fans compared to the similar sized fans. Normally " quiet fans" simply run slower so they don't make as much noise. Though I never specifically looked at the Noctua specs in great detail anyway. But something to bare in mind anyway.
Re: PHIHONG PSM-5341: blown (?) resistor R35
Posted: 10 Apr 2023 20:37
by wolfman
exxos wrote: 10 Apr 2023 20:30
@Steve is right. It's not a good idea to slow down PSU fans. I'm not sure what the airflow is of the Noctua fans compared to the similar sized fans. Normally " quiet fans" simply run slower so they don't make as much noise. Though I never specifically looked at the Noctua specs in great detail anyway. But something to bare in mind anyway.
According to Noctua's specs for this fan:
- 29,2 m³/h (full speed)
- 23,5 m³/h (medium speed)
- 16,7 m³/h (slow speed)
Re: PHIHONG PSM-5341: blown (?) resistor R35
Posted: 10 Apr 2023 20:49
by exxos
wolfman wrote: 10 Apr 2023 20:37
According to Noctua's specs for this fan:
- 29,2 m³/h (full speed)
- 23,5 m³/h (medium speed)
- 16,7 m³/h (slow speed)
Ah. I've only worked with CFM :lol:
Re: PHIHONG PSM-5341: blown (?) resistor R35
Posted: 29 Apr 2023 16:51
by Steve
@wolfman I saw this on Atari forum and thought of you:
https://www.atari-forum.com/viewtopic.php?f=27&t=42737
Re: PHIHONG PSM-5341: blown (?) resistor R35
Posted: 02 May 2023 07:19
by exxos
I think it's important to note that having the fan blowing outwards is better. Some turn them around thinking blowing cool air inside the case is better. But it's not.
It may initially keep the PSU cooler. But your blowing warm air from the PSU inside the case where heat can build up over time. Once heat builds up the ambient temperature effectively is higher and the PSU runs hotter. It's a viscous circle. So it's always better to suck the hot air out of the case and PSU.
I don't think anyone has done any tests on fan speeds Vs temperature. But indeed don't run the PSU without a fan. Best to lookup the airflow rating and replace with a similar spec. Albeit quieter if possible. Should be easy to replace the older ballbearing fans with a fluid bearing type etc.