Re: Video driver thoughts
Posted: 19 Oct 2018 21:25
Yes, that's a good idea, probably only needed for the bit 3 and 4 as after that the increase will be very small.
We welcome retro users & hardware gurus alike! Come and join the party :)
https://www.exxosforum.co.uk/forum/
Don't follow what you mean ?Forgottenmyname wrote: 19 Oct 2018 21:26 At last, an opportunity for a triple decker. Now do I put it over or under the ram board :D
Well I already have the shifter in the adaptor board for your ram expansion.exxos wrote: 19 Oct 2018 21:30Don't follow what you mean ?Forgottenmyname wrote: 19 Oct 2018 21:26 At last, an opportunity for a triple decker. Now do I put it over or under the ram board :D
oh yep :lol:Forgottenmyname wrote: 19 Oct 2018 21:37 Well I already have the shifter in the adaptor board for your ram expansion.
I'm doing it because that what it says in the datasheet.... I to am not sure why the falcon is wired up differently..rpineau wrote: 19 Oct 2018 21:56 I'm not sure about C1, C2 and C3 inline with RGB, the Falcon has 75 ohm resistors inline to match standard line impedance for video signals.
Are you doing this to eliminate any potential DC in the signal ?
Hopefully :) Easy to bridge them over if needs be anyway.rpineau wrote: 19 Oct 2018 22:12 Works for me .. I think the datasheet is probable more accurate than what was done on the falcon :)