You will not be able to post if you are still using Microsoft email addresses such as Hotmail etc
See here for more information viewtopic.php?f=20&t=7296
terriblefire wrote: Wed Jan 22, 2020 8:53 am
Boards posted out to chucky, supaduper, alenppc and go0se
Many thanks & much appreciated!
Were X2 of the -6 variant XC95288XL the final CPLD requirement in the end or did the -10s cut it?
I await the answer with some trepidation!
I've put a 10ns on the bus cpld and a 6ns on the RAMCPLD. The ram CPLD has to cope with 200Mhz in places (clock control).
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Thanks Mark. I notice these are 143 MHz, that enough? There is also a 166 mhz version by ISSI.
The RAM is never run at more than the CPU speed so getting expensive parts isnt necessary.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Got a bunch of family things to sort out today. Cant get a firmware to boot Diagrom in the 20 mins I spent at it.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Ok it boots with a hardware patch.. need to sort the reset lines in firmware then we're good.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
but you want to hurt it some more with a sit at your lab table doing some `Burnination` coding
