But as mentioned above.. that has apparently been removed on newer ATX versions.Tomswork wrote: Fri Dec 13, 2019 5:08 am The white wire on atx supply is minus 5v same as that Atari supply'
Tom
Although its still possible to get ATX v1.0 supplies.
You will not be able to post if you are still using Microsoft email addresses such as Hotmail etc
See here for more information viewtopic.php?f=20&t=7296
See here for more information viewtopic.php?f=20&t=7296
Check if your IP is banned
viewtopic.php?t=7286
viewtopic.php?t=7286
-5v - from an ATX psu?
-
terriblefire
- Admin sponsor
- Posts: 5637
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: -5v - from an ATX psu?
Although its still possible to get ATX v1.0 supplies.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Re: -5v - from an ATX psu?
Interesting I live in Canada and even the latest new psu on the shelf have the minus 5 line as standard on the 20pin and 24 pin connector. Is this a area specific change
Tom
Tom
-
terriblefire
- Admin sponsor
- Posts: 5637
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: -5v - from an ATX psu?
No its an ATX version change. But I suspect nothing actually uses ATX v3.0 yet.Tomswork wrote: Fri Dec 13, 2019 8:08 am Interesting I live in Canada and even the latest new psu on the shelf have the minus 5 line as standard on the 20pin and 24 pin connector. Is this a area specific change
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Re: -5v - from an ATX psu?
Interesting just looked up the ver 3 and pin 20 is now marked nc
I guess I'm getting old
Tom
I guess I'm getting old
Tom
Re: -5v - from an ATX psu?
I think something could be done with the -12v out side with a 7805 zenier diode and resistor how much current does you need on the -5 this is wasteful and will get warm
Tom
Tom
Re: -5v - from an ATX psu?
Try a simple in4007 diode in the input of the 7905 a few capacitors maybe needed
Tom
Tom