Floppy Support

[rubber_jonnie]

Ok, so been having a play, and here are the results, I haven't tried printing yet as already have something else printing, plus I think I still need to tweak the extruder height a smidge as I think my Z offset is too low and I have no room for adjustment!

There are now 4 types, 2 short and 2 tall, with and without slots. I've increased the slot size for ease of 3d printing, or you can print without slots if you'd prefer.

I've also added a chamfer to aid in pushing it into the mainboard.

Tall ones are 20mm total height, short are 17.5mm total height.

They look like this:

Short_Slotted.PNG (189.52 KiB) Viewed 5291 times

Short_No_Slot.PNG (187.58 KiB) Viewed 5291 times

Go have a play

FDD_Tall_Slotted.stl

(75.08 KiB) Downloaded 235 times

FDD_Tall_Not_Slotted.stl

(74.01 KiB) Downloaded 249 times

FDD_Short_Slotted.stl

(71.08 KiB) Downloaded 226 times

FDD_Short_Not_Slotted.stl

(70 KiB) Downloaded 212 times

[rubber_jonnie]

BTW I also printed off 3 of my original design and they all came out ok, even with the really narrow slots, though I think the wider slots will be better.

All fitted into the holes in an ST mainboard with no problem.

[rubber_jonnie]

Also here on Thingiverse: https://www.thingiverse.com/groups/atar ... rts/things

[Maeke]

finishing printing 3 FDD_Tall_Slotted.stl (in dark blue petg).

[rubber_jonnie]

finishing printing 3 FDD_Tall_Slotted.stl (in dark blue petg).

Cool, if you have any photo's that would be awesome.

[Maeke]

as you wish.

[rubber_jonnie]

Oooh, they look nice, do they fit the ST mainboard ok?

[Maeke]

didn't try yet, i am not alone.

[rubber_jonnie]

Not tried yet, am not alone.

Ok, no worries, they look real good though. Exxos is printing some too.

[exxos]

The left post was the one I printed in PLA yesterday.. Basically all slots were melted together..

The middle one I printed just, different settings, and now it looks a lot better.

The one on the right is printed earlier out of ABS, but this one seemed worse than the one yesterday.

I think part of the problem is the now "sloping top". Actually preferred the one yesterday which was more "flat" ? , this pushed into the motherboard and grips just fine. But this new one no longer grips in the board as good due to the "slope".

IMG_3547.JPG (6.32 MiB) Viewed 5263 times

EDIT:

So far I think PLA is getting a bit more detail and less blobbing than ABS. But I printed squares out of ABS which were fantastic. So I think finer/smaller details is better with PLA. Larger objects that may not need fine detail can be done fine in ABS.