Icky - Progress

[exxos]

This is what happens when developers are turned loose to develop in an area with no zoning laws. Complete chaos!! If I'm going to use my ultra satan and the 1772 buffer card I figure I will need 12 sockets to clear the ultra satan connector card. Where will it end! :) :) :)

:lolbig:

[Icky]

Not much progress, as have been restricted from Atari over the weekend, but thought I would sneak this update in of the progress of the board based on a few other threads that were being worked on.

• PSU recapped and re-filmed (metal film resistors replaced) - this was the PSU that had the smelly / hot resistor - https://www.exxosforum.co.uk/forum/viewt ... f=9&t=1327
• Smonson's HDMI / DVI Board - trying this out on the board as it's easier to get to and work on than my STM - https://www.exxosforum.co.uk/forum/viewt ... 260#p14292

IMG_3299.png

[exxos]

:bravo:


When it looks like this, our work is done.

46520103_1926144830800878_2092118341278760960_n.jpg

[Icky]

:bravo:


When it looks like this, our work is done.


46520103_1926144830800878_2092118341278760960_n.jpg

That looks too structured and neat for when we have finished. Wait till you see the IDE test board strapped to the STF Remake. Thinking I may have to build breadboard shelves :D

[PaulJ]

:bravo:


When it looks like this, our work is done.


46520103_1926144830800878_2092118341278760960_n.jpg

That looks too structured and neat for when we have finished. Wait till you see the IDE test board strapped to the STF Remake. Thinking I may have to build breadboard shelves :D

Is that an un-fu*kit drawer on the top of the rack? Its the predecessor to the un-fu*kit board! :cheer: :cheer: :cheer:

[Icky]

That looks too structured and neat for when we have finished. Wait till you see the IDE test board strapped to the STF Remake. Thinking I may have to build breadboard shelves :D

Is that an un-fu*kit drawer on the top of the rack? Its the predecessor to the un-fu*kit board! :cheer: :cheer: :cheer:

I just spotted the rack on the left sporting the two large PSU's I wonder if Exxos does a recap kit for those.

[PaulJ]

Is that an un-fu*kit drawer on the top of the rack? Its the predecessor to the un-fu*kit board! :cheer: :cheer: :cheer:

I just spotted the rack on the left sporting the two large PSU's I wonder if Exxos does a recap kit for those.

I would guess he did, but out of stock now. It was most likely the original booster for an old tube computer!!!

[PhilC]

I wonder if he still has the same lights in his lounge?

[Icky]

Its getting very tight in there. Video DAC board is intruding on the PSU mounts shifting it back a bit.

I think Exxos won't be happy until my PSU is standing at least a foot above the board.

IMG_3321.png

Looking across the STF Remake skyline

IMG_3320.png

[exxos]

I think Exxos won't be happy until my PSU is standing at least a foot above the board.

:lolbig: :bravo:

Probably best I don't start on the 1772 AB swap GAL thing just yet then :P