TF534 Not run

[dragmar]

The plate lay for a long time, I decided to solder it

Even soldering went fast, first I soldered without RAM and checked if it starts. He succeeded and began to solder IC RAM and CPLD. The programming went well. But the card does not boot.

I launched DIAGROM. It took off, I checked the RAM and it turned out that the photo will show it better

Where is the best place to look for the fault?

[arkadiusz.makarenko]

It looks like ram issue to me.
Can you do slow manual test fastram region 0x40000000 - 0x4040000 ?

[PaulJ_2.0]

That ram config is quite normal.

https://www.exxosforum.co.uk/forum/viewt ... 5&start=60

[dragmar]

I started checking IC8 connections. It turned out that the pin had no contact with VCC and A21.

The diagram still shows this error, but I already know it is. THX @ PaulJ_2.0

But I have another problem. The card takes off, but ...
AmigaTestKit shows detected FASTRAM - 4MB.

IMG_20200810_195724.jpg (123.92 KiB) Viewed 6729 times

But when I choose DIRECT MEMORY SCAN the system does not see 4MB

IMG_20200810_195802.jpg (125.91 KiB) Viewed 6729 times

[arkadiusz.makarenko]

I have got the same on my TF534.

[PhilC]

Can you do a manual memory test? $4000000 - $403fffff if I remember correctly?

[PaulJ_2.0]

I use this and find it works great and finds any actual errors:
https://archive.org/details/Advanced_Am ... -30_Wilcom

[dragmar]

Can you do a manual memory test? $4000000 - $403fffff if I remember correctly?

@PhilC I cannot do a manual test, I only have the 8A1 board, the GOTEK and the mouse connected.
But it does the test https://archive.org/details/Advanced_Am ... -30_Wilcom
it's okay so far

IMG_20200810_205142.jpg (180.97 KiB) Viewed 6709 times

I took out the AMIGA board to test the card. Ultimately, the TF534 will land in the ATARI 520ST.

[PaulJ_2.0]

That ram is fine if it does 10 passes with no issues.

[arkadiusz.makarenko]

@dragmar
You could do manual test on Diagrom.

But this card look good for me.