RGB2HDMI mod for the Atari STacy

[Darklord]

I had a few people ask if the RGB2HDMI mod for the ST also allowed mono (hi-res) mode. It does, and in the pictures below you can see it in action. On the ST, simply grounding pin #4 on the video port causes it to go into mono/hi-res mode (assuming your display can handle it). Adding a simple mini-toggle switch gives you the easy ability to switch back and forth between color and mono modes (after a reboot). So my STacy can now do lo-res, medium-res and hi-res. Yay!

8.JPG (143.36 KiB) Viewed 480 times

9.JPG (192.09 KiB) Viewed 480 times

[Darklord]

Oh, here's some pictures of medium resolution as well:

(Yes, with the RGB2HDMI mod you can run -2- screens at once!)

4.JPG (144.71 KiB) Viewed 479 times

5.JPG (167.32 KiB) Viewed 479 times

6.JPG (163.12 KiB) Viewed 479 times

7.JPG (205.36 KiB) Viewed 479 times

[HigashiJun]

Nice !

[alexh]

Very nice.

[Darklord]

BTW, here is what you get if you leave your SC1224 plugged into the external color monitor port on the STacy,
while running in hi-res mode.

[HigashiJun]

@Darklord

And there's no workaround ?

[Darklord]

@Darklord

And there's no workaround ?

Honestly, I'm not sure. It's not unexpected. After all, the SC1224 is a color
monitor that only handles low and medium resolutions.

I'm sure if you plugged an SM124 monitor into the external monitor port it
(the STacy screen) would work fine, but I don't have one.

The SC1224 works fine plugged in as long as the STacy is in low or medium
resolution.

Apparently, you just can't "mix and match".

[HigashiJun]

Yes, it makes sense.

[Darklord]

I've not tried it just yet (but will later some time), but I'm betting my
Dell 27" monitor with the UBE style VGA adapter will work fine with
all 3 ST resolutions from the STacy's external monitor port.

Will report back when I do.