- Gotek HD Floppy Jumper to Remove HD Select Wire
PaulJ wrote: ↑Thu May 21, 2020 6:50 pm
@Icky to have the floppy HD selection work with a gotek it needs a jumper from floppy pin 32 to the drive 0 main board jumper. Is there any chance to get this put in as a lan since this floppy connector pin has no existing connection?
@PaulJ suggested we had a jumper to help send the HD select line on Pin 2 of the Floppy connector if using a Gotek.
@kodak80 did a good guide on using a separate cable but by having a jumper on the board you can just use the Floppy cable.
HD guide -
https://www.exxosforum.co.uk/forum/viewt ... 551#p33807
To achieve this feature we have extended JP18 to have three pins. If you have the HD mod fitted and are using a Gotek with its config changed by placing the jumper on pins 2 and 3 you don't need an extra cable to the Gotek.
EDIT: After a bit of research by
@exxos we have established Pin 2 on floppy drives are not connected so we have gone back to a two pin jumper and directly connected the HD Select line to Pin 2 on the floppy header.
- Screenshot 2020-06-04 at 17.10.36.png (207.37 KiB) Viewed 5288 times