OK i'll put a 120Mhz crystal on there and be a sneaky SOB.exxos wrote: Fri Apr 10, 2020 4:29 pm
The CPU max about 64mhz but likely be 50mhz for normal usage. Anything above 50MHz is down to "overclocking" and I doubt people will get much past 64MHz there.
Edit.
https://www.exxosforum.co.uk/forum/viewt ... 510#p32482. Couldn't get past 75mhz, needed freezer spray at that point
Can all registered uses please login, even just for a few minutes..
It helps build a picture where our "good traffic" is coming from..
Thanks :)
It helps build a picture where our "good traffic" is coming from..
Thanks :)
If anyone wants a project..
-
terriblefire
- Admin sponsor
- Posts: 5687
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: If anyone wants a project..
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Re: If anyone wants a project..
In regards to the original 16MB find from @exxos we could test it out with a modified Three Amigos board on the H4 as pointed out the H4 has a SIMM already and waiting for a MAD10 line.
I just threw a PLD in between the GLUE Socket and Connector to get the MAD10 line out with a few other IO's for testing as well.
I just threw a PLD in between the GLUE Socket and Connector to get the MAD10 line out with a few other IO's for testing as well.
- Screenshot 2020-04-11 at 12.44.19.png (202.6 KiB) Viewed 4974 times
Re: If anyone wants a project..
So this will give us 14mb then?
If it ain't broke, test it to Destruction.
Re: If anyone wants a project..
In theory yes. Doubt it be that simple though.
-
terriblefire
- Admin sponsor
- Posts: 5687
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: If anyone wants a project..
I dropped the ram board before i got sick i'll pick up again.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Re: If anyone wants a project..
terriblefire wrote: Thu May 07, 2020 9:34 am I dropped the ram board before i got sick i'll pick up again.
