Building a DIY large bed 3D printer

[Icky]

Yet another project hits my list. I have started looking at building a DIY 3D printer to be able to print a full sized ST Case we have been working on. https://www.exxosforum.co.uk/forum/viewt ... 341#p24793

The current build area for my project is 550mm x 350mm x 250mm to be able to print a whole case section, as well as not to be too big to fit in the house , and the printer is based on the Voron 2.1 http://vorondesign.com/voron2.1

Partly this is for the fun of building my own 3D printer but at the same time help the STFM case project along.

I have ordered several parts already and will update on the build here.

[PhilC]

Cool, that was on my list too.

I have some pcb bits etc if you want them?

[exxos]

If my old 3D printer is any good, you could salvage some motors off it or something ?

[PhilC]

Actually that would be a good donor exxos but will depend on the style of printer Icky is building.

What you planning on Icky? Mines a prusia based printer which are easy to build and tweak.

[Icky]

I have some pcb bits etc if you want them?

Thanks PhilC. At the moment I have just got the frame and mechanical bits to do first as those have been ordered. Will look at the electronics a bit later.

If my old 3D printer is any good, you could salvage some motors off it or something ?

Thanks Exxos. I have ordered the motors already. What model was your old printer?

Actually that would be a good donor exxos but will depend on the style of printer Icky is building.

What you planning on Icky? Mines a prusia based printer which are easy to build and tweak.

It is a Voron 2 build. I looked at several Core XY DIY type builds but eventually went down the Voron route. This was an interesting comparison of what is out there https://mechlab.cc/which-corexy-voron-v ... rcube-evo/

[exxos]

Thanks Exxos. I have ordered the motors already. What model was your old printer?

https://www.exxosforum.co.uk/forum/viewt ... =63&t=1799

[Icky]

Parts have started to trickle in this morning. Postman was a bit weighed down with the metal frame and stepper motor components.

ST mouse for scale next to the frame pieces, it's going to be one big printer.

Now I have the mammoth task of printing out all the additional parts in ABS on my old printer.

IMG_4332.jpg (100.75 KiB) Viewed 6876 times

IMG_4331.jpg (81.02 KiB) Viewed 6876 times

[exxos]

oooooooo new toys

[Icky]

I have also been looking at the following HR-PLA 3D870 https://filament2print.com/gb/special-p ... 3d870.html which is supposedly PLA similar to ABS properties. In addition you can temper it to make it harder.

Wonder if anyone has tried it?

[PhilC]

That material looks interesting. I've got a roll of Tpu to try too.