Possible sale of 2 xShort ST STM 520 4MB with ST536 built in

Post by **exxos** » Fri Feb 28, 2025 9:15 pm

@PhilC Looks like it can go about 3cm.. but is that going to be enough anyway..

Post by **PhilC** » Fri Feb 28, 2025 9:35 pm

exxos wrote: ↑Fri Feb 28, 2025 9:15 pm @PhilC Looks like it can go about 3cm.. but is that going to be enough anyway..

I would have thought so but can't say exactly until I'd try it

Post by **PhilC** » Sat Mar 01, 2025 10:23 am

exxos wrote: ↑Fri Feb 28, 2025 9:15 pm @PhilC Looks like it can go about 3cm.. but is that going to be enough anyway..

Ok, this is where the plug would be if it was moved along 30mm

mrbombermillzy · Post by **mrbombermillzy** » Sat Mar 01, 2025 10:46 am

Looks to me as ending on the 13th pin row in from the back of the machine, to be safe, or any further back if possible.

Post by **exxos** » Sat Mar 01, 2025 12:34 pm

PhilC wrote: ↑Sat Mar 01, 2025 10:23 am Ok, this is where the plug would be if it was moved along 30mm

25mm ?

Post by **PhilC** » Sat Mar 01, 2025 1:11 pm

exxos wrote: ↑Sat Mar 01, 2025 12:34 pm
PhilC wrote: ↑Sat Mar 01, 2025 10:23 am Ok, this is where the plug would be if it was moved along 30mm
25mm ?

If you say 20mm next, I swear I will drive up there and

Post by **exxos** » Sat Mar 01, 2025 2:55 pm

Image to dark to see :p

You could just center the connector between the keyboard and rear connector and tell me what looks best

. I guess 20mm or 18mm is about as good as it can be...

Post by **PhilC** » Sat Mar 01, 2025 3:02 pm

So how would you like me to measure it? From the left edge as per photo of how?

Post by **exxos** » Sat Mar 01, 2025 3:36 pm

PhilC wrote: ↑Sat Mar 01, 2025 3:02 pm So how would you like me to measure it? From the left edge as per photo of how?

I need to know how far apart the left sides of the IDE connectors are.. whatever is the ideal measurement I can move it on the PCB by..

Post by **PhilC** » Sat Mar 01, 2025 4:25 pm

@exxos 22mm from left corner in photo to IDE header pins.