BlowUp has been released by its author and can be copied freely.

The serial number is: H1150634

Please run the installation program on the disk image to install the software.
Do not try and copy the files manually as it will leave you with a crippled
demo version.

---

The configuration of BlowUp (video modes / screen resolutions) depends a lot
on the monitor you use. Below are three configurations that can be used with
the 50MHz oscillator. The configurations are for 2, 4, and 16 colors with a
resolution of 1024x768. Whether or not you can make use of these depends on
the frequencies supported by your monitor.

MS 1024 768 0 2 1216 64 128 244 816 32 784 2 1 50.000000
MS 1024 768 0 2 1216 52 140 244 816 32 784 2 2 50.000000
MS 1024 768 0 2 1216 64 128 244 816 32 784 2 4 50.000000

To apply these do the following:
1. Install the BlowUp software.
2. Make sure BLOWBOOT.PRG is in AUTO folder and is the last program to execute.
3. BLOWACC.ACC should be in C: root (assuming you boot from C:).
4. Edit the DEFAULT.BCF file and add the three lines found above.
5. Start BLOWCONF.PRG.
6. Enable the multi-sync mode by clicking the button MS 1/2.
7. Load one of the 1024x768 configurations, click SAVE BOOT.
8. Repeat for the other two 1024x768 configurations.

SAVE BOOT will save the current loaded configuration to BLOWBOOT.PRG so that
you can configure what resolution to use for different color depths using
BLOWACC.ACC. Note when later on specifying a video mode in BLOWACC.ACC it will
not actually change the video mode. The setting will be applied the next time
you change video mode using the Desktop menu.
